Associated-equipment 8600-KSA Manuel d'utilisateur
Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Associated-equipment 8600-KSA. Associated Equipment 8600-KSA User Manual Manuel d'utilisatio
- Page / 8
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ALTERNATOR - STARTER TESTER
ASSOCIATED
Model 8600-KSA/8503A
OPERATION AND MAINTENANCE MANUAL
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for the
alternator/starter tester 8600-KSA/8503A. You may need to refer to these instructions at a later date.
CAUTION: THE WEIGHT OF THE INDIVIDUAL COMPONENTS AND/OR THE ASSEMBLED UNIT MAY EXCEED
THE SAFE LIMIT THAT MAY BE LIFTED BY ONE INDIVIDUAL. EXTREME CARE SHOULD BE
EXERCISED WHEN HANDLING THIS MACHINE!
a) Always wear safety glasses while conducting tests. Foreign matter in the device being tested may fly out at high
speed and cause personal injury.
b) Keep fingers, loose clothing, ties, etc. away from the “V” belt drive components, rotating pulleys, fans, and starter
drive mechanisms.
c) Make sure the device under test is mechanically secure prior to the start of testing.
d) Keep one hand on the vise knob to stabilize the unit under test and the other hand on the test switch.
e) Use only a properly grounded, 16 AMP, 220 VAC, 60 Hz. dedicated receptacle. Wire supplying power to this
receptacle should be no smaller than 12AWG.
CAUTION - Do not remove the ground prong from the line cord as
you are defeating a safety feature. Removing the ground prong could cause a harmful shock.
f) Use of an extension cord is not recommended. Tester performance may be degraded and it may also cause serious
internal heating in the machine.
g) Do not use outdoors, near flammable materials, or with extension cords. Use good judgement whenever operating
any electrical appliance.
h) Replace frayed or worn power cords and operate only in dry areas.
I) Keep away from children.
j) It is of the utmost importance that this test equipment be used only by a qualified, trained operator.
INTRODUCTION
Your test bench is designed and manufactured to provide you with a state of the art, quality, accurate, sturdy piece of
equipment, and is intended to quickly and easily determine the condition of Starters and both internal and external
regulated Alternators.
The test bench is completely self contained and does not require the use of external automotive type batteries. This
feature alone results in customer convenience, safety, and overall reduced operating cost. The only requirement is that
the test bench be plugged into a dedicated 230 VAC, 60 Hz. receptacle. It is suggested that the wire to the receptacle be
no smaller than #12 AWG.
Some older buildings may require new wiring to be installed for your tester; consult a licensed electrician if you are unsure
of your wiring. It is also suggested that the tester be protected with a 20 AMP breaker or fuse. If your service is fused, it
should be of the slow blow type.
To prevent the possible ignition of fuel fumes found in some shops, and to aid in operator convenience and safety, the
tester must be operated at a minimum of 18 inches above the shop floor. The test bench can be conveniently operated
on a counter to demonstrate to the customer the conditions of his electrical device.
1
Résumé du contenu
Page 1 - Model 8600-KSA/8503A
ALTERNATOR - STARTER TESTER ASSOCIATED Model 8600-KSA/8503A OPERATION AND MAINTENANCE MANUAL IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
Page 2 - Additional Features:
2SPECIFICATIONS Cabinet Dimensions: Height: 17 inches, Width: 14 inches, Depth: 28 inches Shipping Weight: 108 Lbs.. Line Under voltage Alarm Point:
Page 3
3ASSEMBLY INSTRUCTIONS CAUTION: THE WEIGHT OF THE INDIVIDUAL COMPONENTS AND/OR THE ASSEMBLED UNIT MAY EXCEED THE SAFE LIMIT THAT MAY BE LIFTED BY O
Page 4
4 f) Connect the small Green lead (FIELD) to the terminal marked "F", "FLD", or "FIELD" on alternators so equipped. g)
Page 5 - TROUBLESHOOTING GUIDE
5f) Hold the Starter Test Switch; the Starter should engage and spin up. Observe the meter reading. Check the no-load current draw against the pub
Page 6
6 PROBLEM TEST POSSIBLE CAUSE Power Lamp is inoperative. No meter readin . gMotor won't run. Motor switch is ON. Belt guard is down. 1. Unit
Page 7 - REPLACEMENT PARTS
REPLACEMENT PARTS Key Description Part # A Univ. Test Lead Set 610421 B Starter Test Switch 610422 C Power Off/On Switch 610423 D Motor Swit
Page 8 - LIMITED WARRANTY
8LIMITED WARRANTY Associated Equipment Corporation, 5043 Farlin, St. Louis, Missouri 63115, makes this limited warranty to the original and user pur
Produits connexes et manuels pour Équipement Associated-equipment 8600-KSA
(7 pages)
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels